詳細ガイド 近日公開
Launch Angle & Exit Velocity Analyzerの包括的な教育ガイドを準備中です。ステップバイステップの解説、数式、実例、専門家のヒントをお届けしますので、もうしばらくお待ちください。
Before Statcast arrived in all 30 MLB parks in 2015, baseball evaluation was fundamentally limited by what human eyes could observe. Launch angle and exit velocity changed everything. These two measurements — derived from high-speed cameras and Doppler radar tracking every batted ball — revealed that the traditional advice 'hit the ball on the ground' was actively harming hitters. The data showed unambiguously that balls hit at optimal launch angles with high exit velocities produce dramatically more runs than any other contact type. Exit velocity measures how fast the ball leaves the bat in miles per hour. An average exit velocity of 88–90 mph is league average. Elite contact like Aaron Judge's 2022 season saw average exit velocities above 95 mph — among the highest ever recorded. The hardest-hit balls in history regularly exceed 115–120 mph. Exit velocity correlates strongly with expected outcomes: balls hit above 95 mph have dramatically better hit probabilities than softer contact. Launch angle measures the vertical angle at which the ball leaves the bat, from -90 (straight down) to +90 (straight up). The Statcast research that shocked the industry showed the 'sweet spot' for hits and extra-base hits falls between approximately 8–32 degrees. Line drives (10–25 degrees) become hits roughly 65–70% of the time. Fly balls (25–50 degrees) become home runs at rates that increase sharply with exit velocity. Ground balls (below 10 degrees) become hits only about 25% of the time. The 'barrel' classification — pioneered by Statcast — combines both metrics: a batted ball is a barrel if its exit velocity and launch angle combination puts it in a zone where MLB hitters hit .500 or better with a 1.500 slugging percentage. Barrels are the gold standard of contact quality. Freddie Freeman, Juan Soto, and Aaron Judge consistently rank at the top of barrel rate leaderboards. Understanding launch angle and exit velocity has transformed hitting instruction at every level. Coaches now use launch angle data to teach hitters to 'attack the bottom of the ball' for optimal lift, moving away from decades of ground-ball-focused philosophy. The Statcast era has produced a home run surge that reflects this fundamental shift in hitting approach.
Exit Velocity: Measured directly by Statcast radar in mph — no calculation required for raw measurement. Launch Angle: Measured directly by Statcast cameras in degrees above/below horizontal. Expected Batting Average (xBA) based on EV and LA: xBA = f(Exit Velocity, Launch Angle) — a lookup from Statcast's probability model Barrel Definition: A batted ball is a 'barrel' if: - Exit Velocity ≥ 98 mph AND Launch Angle between 26–30° at 98 mph - As EV increases above 98 mph, the qualifying LA range expands - At 116+ mph, any LA from 8–50° qualifies as a barrel Expected Slugging (xSLG) Approximation by Zone: - Ground Ball (LA < 10°): xSLG ≈ 0.35–0.45 (even at high EV) - Line Drive (LA 10–25°): xSLG ≈ 0.65–0.95 - Fly Ball Sweet Spot (LA 25–35°, EV > 95): xSLG ≈ 1.20–2.00+ - Pop Up (LA > 50°): xSLG ≈ 0.05–0.10 Worked Example: Aaron Judge hits a ball at 112 mph, 28° launch angle. This is well inside the barrel zone → xBA ≈ .780, xSLG ≈ 1.850 (near-certain home run or extra-base hit)
- 1Exit velocity is captured by Hawk-Eye Statcast cameras and Trackman radar installed in all 30 MLB stadiums, measuring the ball's speed off the bat to the nearest tenth of a mph within milliseconds of contact.
- 2Launch angle is simultaneously captured by the same camera system, measuring the vertical departure angle of the ball from horizontal — negative values indicate downward contact (ground balls), positive values indicate upward contact.
- 3Analysts plot every batted ball on an exit velocity vs. launch angle scatter chart to identify the 'hot zones' where hits and extra-base hits cluster most densely.
- 4The barrel zone — approximately EV ≥ 98 mph and LA between 26–30° (expanding as EV increases) — represents the combination where batters historically achieve .500 BA or higher, making it the ideal contact target.
- 5Barrel rate (barrels per plate appearance or per batted ball event) summarizes a hitter's ability to consistently reach the barrel zone, serving as a leading indicator of future slugging and power production.
- 6Expected batting average (xBA) and expected slugging (xSLG) use the full distribution of all historical Statcast outcomes at each EV/LA combination to estimate what a player's stats should be based on contact quality alone.
- 7The difference between actual stats and expected stats (BA minus xBA, SLG minus xSLG) reveals luck — large positive gaps indicate unsustainable performance, large negative gaps indicate positive regression incoming.
Judge's 62-HR season featured the highest average EV in baseball (95.2 mph avg) and a barrel rate above 25%. Every metric predicted his historically great season before it fully materialized.
A softly hit ground ball at -5 degrees has very low hit probability regardless of speed. This is the contact type that inflates BABIP when it falls in but is unsustainable as a production strategy.
A 102-mph line drive at 18 degrees sits in the heart of the line-drive sweet spot. This ball will be a double or triple most of the time and represents excellent contact quality even without reaching barrel classification.
Even at league-average exit velocity, a pop-up at 65 degrees almost never becomes a hit. This is the worst batted-ball outcome a hitter can produce — it's why low popup rates are a valuable contact quality indicator.
Hitting coaches at all levels use launch angle tracking technology (Rapsodo, HitTrax) to diagnose swing mechanics and give hitters real-time feedback on contact quality, replacing subjective 'feel' coaching with objective data.
Professionals in engineering and electrical use Launch Angle Exit Velocity as part of their standard analytical workflow to verify calculations, reduce arithmetic errors, and produce consistent results that can be documented, audited, and shared with colleagues, clients, or regulatory bodies for compliance purposes.
University professors and instructors incorporate Launch Angle Exit Velocity into course materials, homework assignments, and exam preparation resources, allowing students to check manual calculations, build intuition about input-output relationships, and focus on conceptual understanding rather than arithmetic.
Consultants and advisors use Launch Angle Exit Velocity to quickly model different scenarios during client meetings, enabling real-time exploration of what-if questions that would otherwise require returning to the office for detailed spreadsheet-based analysis and reporting.
Coors Field significantly inflates fly ball distances due to altitude (5,280
Coors Field significantly inflates fly ball distances due to altitude (5,280 feet), meaning balls that are outs at sea-level parks become home runs at Coors — exit velocity and launch angle metrics must be park-adjusted for Colorado-based analysis.
Bunts and checked-swing contact produce very low exit velocities but can be
Bunts and checked-swing contact produce very low exit velocities but can be hits for extremely fast runners — speed-adjusted expected stats (using Sprint Speed) partially account for this but the models are imperfect for extreme speed outliers like Byron Buxton.
Left-handed hitters at Yankee Stadium benefit from an extremely short
Left-handed hitters at Yankee Stadium benefit from an extremely short right-field porch (314 feet), turning balls with moderate exit velocity and launch angle into home runs that would be outs in most parks — park-neutral xSLG corrects for this.
| Launch Angle Zone | EV Range | Approx. Hit Rate | Typical Outcome |
|---|---|---|---|
| Ground Ball (< 10°) | Any | ~24–26% | Single, double play, or out |
| Line Drive (10–25°) | 88–94 mph | ~65–70% | Single or double |
| Line Drive (10–25°) | 95+ mph | ~75–85% | Hit, often double or triple |
| Fly Ball Sweet Spot (25–35°) | 98–104 mph | ~55–70% | Home run or deep fly out |
| Barrel (26–30°) | 98+ mph | ~78%+, SLG 1.500+ | Home run most of the time |
| Pop Up (> 50°) | Any | ~2–5% | Near-automatic out |
What is the ideal launch angle for hitting a home run?
Launch Angle Exit Velocity is a specialized calculation tool designed to help users compute and analyze key metrics in the engineering and electrical domain. It takes specific numeric inputs — typically drawn from real-world data such as measurements, rates, or quantities — and applies a validated mathematical formula to produce actionable results. The tool is valuable because it eliminates manual calculation errors, provides instant feedback when exploring different scenarios, and serves as both a decision-support instrument for professionals and a learning aid for students studying the underlying principles.
What exit velocity is considered elite in MLB?
In the context of Launch Angle Exit Velocity, this depends on the specific inputs, assumptions, and goals of the user. The underlying formula provides a deterministic relationship between inputs and output, but real-world application requires interpreting the result within the broader context of engineering and electrical practice. Professionals typically cross-reference calculator output with industry benchmarks, historical data, and regulatory requirements. For the most reliable results, ensure inputs are sourced from verified data, understand which assumptions the formula makes, and consider running multiple scenarios to bracket the range of likely outcomes.
Can a ball with low exit velocity still be a hit?
In the context of Launch Angle Exit Velocity, this depends on the specific inputs, assumptions, and goals of the user. The underlying formula provides a deterministic relationship between inputs and output, but real-world application requires interpreting the result within the broader context of engineering and electrical practice. Professionals typically cross-reference calculator output with industry benchmarks, historical data, and regulatory requirements. For the most reliable results, ensure inputs are sourced from verified data, understand which assumptions the formula makes, and consider running multiple scenarios to bracket the range of likely outcomes.
What is a barrel rate and what is considered good?
A good or normal result from Launch Angle Exit Velocity depends heavily on the specific context — industry benchmarks, personal goals, regulatory thresholds, and the assumptions embedded in the inputs. In engineering and electrical applications, practitioners typically compare results against published reference ranges, historical performance data, or regulatory standards. Rather than viewing any single number as universally good or bad, users should interpret the output relative to their specific situation, consider the margin of error in their inputs, and compare across multiple scenarios to understand the range of plausible outcomes.
How has launch angle data changed hitting instruction?
In the context of Launch Angle Exit Velocity, this depends on the specific inputs, assumptions, and goals of the user. The underlying formula provides a deterministic relationship between inputs and output, but real-world application requires interpreting the result within the broader context of engineering and electrical practice. Professionals typically cross-reference calculator output with industry benchmarks, historical data, and regulatory requirements. For the most reliable results, ensure inputs are sourced from verified data, understand which assumptions the formula makes, and consider running multiple scenarios to bracket the range of likely outcomes.
Does Statcast data work in minor leagues?
Hawk-Eye Statcast is installed in Double-A and Triple-A parks, and limited tracking exists at some lower levels. MLB teams use this data extensively for prospect evaluation — a minor league power hitter with elite exit velocity and barrel rate is far more projectable than one with traditional scouting marks alone.
What is the difference between hard-hit rate and barrel rate?
In the context of Launch Angle Exit Velocity, this depends on the specific inputs, assumptions, and goals of the user. The underlying formula provides a deterministic relationship between inputs and output, but real-world application requires interpreting the result within the broader context of engineering and electrical practice. Professionals typically cross-reference calculator output with industry benchmarks, historical data, and regulatory requirements. For the most reliable results, ensure inputs are sourced from verified data, understand which assumptions the formula makes, and consider running multiple scenarios to bracket the range of likely outcomes.
プロのヒント
Use the gap between a hitter's xSLG and actual SLG over a rolling 60-day window to identify the best buy-low targets. If xSLG is .520 and actual SLG is .380, the hitter is producing elite contact quality but not being rewarded — almost always a temporary condition that corrects sharply.
ご存知でしたか？
Giancarlo Stanton holds the Statcast-era record for the hardest-hit ball ever recorded — a 122.2 mph exit velocity blast in 2016 against the Cubs. At that speed, the ball traveled from bat to the warning track in approximately 3.8 seconds, giving outfielders almost no time to react.